For today’s class we had to finalise everything so that we could start working on our model. We started with the material list. We came up with a list of materials , we were supposed to make 3 different sets of the material list, since our point of contact was kabaddi [pulling the leg] we had two wearable’s one on the hand and the other one on the leg, the material list for the handle included metal sheets, m seal and clay. The material list for the leg included silicon, wood, rubber, clay, Lycra, metal, wax, sand paper, kinetic sand, heating pad.
By the end of the first class we were ready with our measurements and our material list. Now we had to start making our prototypes to figure out which material would be suitable and how would the final model function.
We made our prototype with metal, clay, sand paper and ohp sheet. After getting the prototype approved sir told us to start working on our main model now.
The materials required for the main model were :- Wood [which we bought from byculla], [tyres which we found from a local cycle repair shop], Metal sheet [which we bought from grant road] , hinges , screws, magnets, kinetic sand [from a local toy shop] and sand paper.
Drishti Doshi 